In this study, TiO2 micro-flowers learn more composed of nanotubes were fabricated by means of dot patterning, Ti etching, and anodizing methods. The dot patterning and etching of Ti substrates increased the anodizing area to form TiO2 nanotubes. By controlling the anodizing time, beautiful TiO2 micro-flowers were successfully made to bloom on Ti substrates and were applied to the photoelectrodes of DSCs. To the best of our knowledge, this is the first study to report the fabrication of TiO2 micro-flowers and their application to DSCs. The TiO2 micro-flower
structure is strongly expected to enhance the possibility to overcome the limitations of the TiO2 nanoparticle structure. Methods To fabricate the protruding dot patterns on a 0.5-mm-thick Ti foil (99%, Alfa Aesar Co., Ward Hill, MA, USA), 5-μm-thick negative photoresists
(PR; L-300, Dongjin Co., Hwaseong-Si, South Korea) were coated Adriamycin mw on a flat layer of Ti foil using a spin coater (Mark-8 Track, TEL Co., Tokyo, Japan). The coated photoresists were softly baked at 120°C for 120 s and hardly baked at 110°C for 5 min. A dot-patterned photomask was used for PR, the patterning process via UV light exposure. UV light having an energy of 14.5 mJ/s was used for illumination for 5 s, and the PR were developed. The PR at areas not exposed to UV light were removed. The PR-patterned Ti foil was dry-etched at 20°C for 30 min using reactive PI3K Inhibitor Library clinical trial Tolmetin ion etching (RIE) equipment (ICP380, Oxford Co., Abingdon, Oxfordshire,
UK). BCl3 and Cl2 were used as the etchant gas in the RIE process with a top power of 800 W and a bottom power of 150 W. The photoresists on the UV-exposed area served to protect the flat Ti surface during the RIE process. Only the Ti surface at the area not exposed to UV was etched out. The remaining photoresist after the RIE process was stripped at 250°C for 20 min using a photoresist stripper (TS-200, PSK Co., Hwaseong-si, South Korea). O2 and N2 gases were used to remove the photoresist at a power of 2,500 W. Before the anodizing process, Ti foil samples patterned with protruding dots were successively sonicated with acetone, ethanol, and deionized (DI) water to remove any residue on their surfaces. TiO2 micro-flowers, consisting of TiO2 nanotubes, were fabricated by the anodization of the Ti foil sheets which had been patterned with protruding dots in an ethylene glycol solution containing 0.5 wt% NH4F. A constant potential of 60 V with a ramping speed of 1 V/s was applied between the anode and the cathode. Pt metal was used as a counter cathode. The anodizing time was controlled for the successful blooming of the TiO2 micro-flowers. The as-anodized TiO2 nanotubes were rinsed with DI water and annealed at 500°C for 1 h. The morphologies of the TiO2 nanotubes and the micro-flowers were studied by field emission scanning electron microscopy (FESEM, Hitachi SU-70, Tokyo, Japan).