, Ltd., Shanghai, China). The DNA-PK inhibitor colour aberration (ΔE) was calculated according to formula (2): (2) where L x , a x and b x are the lightness, redness-greeness and yellowness-blueness, respectively.

These parameters of the samples before and after ageing were measured by Transmembrane Transporters inhibitor a colour spectrometer (CR-10, Minolta Co., Osaka, Japan). The surface morphology and roughness of the composites before and after ageing were studied by Atomic force microscopy (AFM) (Nanoscope Multimode APM, Vecco Instrument, Plainview, NY, USA) with a tapping mode under ambient condition. Results and discussion Figure 1 shows the FT-IR spectra of the unmodified nano-TiO2 and the modified nano-TiO2. The band around 3,421 and 1,637 cm-1 could be assigned to the hydroxyl groups on the surface of nano-TiO2. Compared with the spectrum of unmodified nano-TiO2, two absorbance peaks emerge around 2,936 and 2,868 cm-1 for the modified sample, which corresponds to the CH2 and CH3 stretching, respectively [15, 35]. The result indicates that the organic functional groups were grafted to the nano-TiO2 during the surface modification. It is suggested that the hydroxyl groups on the surface of nano-TiO2 are active sites for the reaction with aluminate coupling agent

[36, 37]. Here, we detected the crystalline structure of the nano-TiO2 before and after the surface modification, and Figure 1 Inset shows that the sample stays in rutile phase in the experiments. selleck screening library Figure 1 FT-IR spectra of the nano-TiO 2 . (a) Without modification and (b) modified with aluminate coupling agent. Inset, XRD patterns of the nano-TiO2 before and after the surface modification. The surface modification with coupling agent could graft organic groups to the nano-TiO2 particle and then transform its hydrophilic character to a hydrophobic character. We proved this effect by comparing the contact angle of the nano-TiO2 sheets before and after surface modification. As shown in Figure 2a,b,c, the DI water spreads on the sample without modification quickly, and the contact angle reduces to be nearly

0° after 10 s, indicating a well hydrophilicity for the nano-TiO2 without surface modification. It can be attributed to the Unoprostone high surface energy of the nano-TiO2. By contrast, the sample with modification shows a stable contact angle (Figure 2d,e,f). The value is still of about 90° when the contacting time is 10 s, which indicates a hydrophobic characteristic. Figure 2 Wetting and spreading images of the nano-TiO 2 samples. (a to c) Without modification and (d to f) modified with aluminate coupling agent. Particle size distribution of the nano-TiO2 particles was determined by DLS. As shown in Figure 3a, the size distribution of the nano-TiO2 without modification mainly ranges from 200 to 600 nm, and the average particle size can be evaluated to be 303 nm.