This higher density and easier probe positioning decrease spatial variability and therefore improve reproducibility of flux recorded with single-point LDF on the finger pad compared with the forearm [114]. This is untrue when data are expressed as a function of baseline, probably because of the influence of recording conditions on basal digital skin blood flux. One major limitation of laser techniques is that they do not provide absolute perfusion values (i.e., cutaneous blood flow in mL/min

relative to the volume or weight of tissue) [25]. Measurements are often expressed as arbitrary PU and referred to as flux. Some groups have proposed to take into account blood pressure variations when expressing laser Doppler data [25]. They correct for the short-term and long-term variations in blood pressure, which would result in variations in cutaneous blood flow. However, this approach may be hampered by regional blood flow autoregulation. www.selleckchem.com/products/ly2157299.html Blood flow autoregulation is the adjustment of vascular resistances to maintain constant flow over a wide range of pressures. This phenomenon is very efficient in the “protected” cerebral, coronary, and renal circulatory systems, while it is much inferior in skeletal muscle and intestinal circulation, and absent in pulmonary circulation [138]. However,

there is little information concerning the relationship between systemic blood pressure and skin perfusion pressure. Using large cutaneous island flaps in anesthetized dogs, it aminophylline was shown that a decrease in cutaneous blood pressure was linearly selleck inhibitor correlated with a decrease in cutaneous blood flow, with no evidence of any plateau at a given flow value in this model [47], suggesting a lack of consistent autoregulation [58]. Therefore, it would be wise to correct for cutaneous blood flux by mean arterial pressure, or if possible, by using peripheral blood pressure. When blood pressure is taken into account, expressing data as conductance is more appropriate than when data are expressed as resistance

[107]. However, this does not permit the comparison of absolute flux or conductance values across studies in which different probes and/or brands of device and/or sites of measurement are used. An illustration of this issue is the comparison between LSCI and LDI. Although both signals (expressed as perfusion units) are very well correlated (R > 0.85) [98,127], there is a proportional bias between the two techniques whether data are expressed as raw PUs or as a percentage increase from baseline, suggesting that one should not assimilate PUs provided by the two systems [98]. The consequence of the latter limitation is that baseline flux or baseline CVC is of little interest when considered individually. Instead, microvessels are challenged with the various tests described in this review. Data are then expressed as raw flux or CVC, as a function of baseline (i.e.